/ Issue: 

The printer feeding a lot of labels and starts beeping and flashing in CONDITION og ERROR slowly at the same time.


/ Solution no. 1 (Sensor adjustment):

  1. Open topcover and printheadsection (Blue button)
  2. Remove the labels
  3. Push the sensor to right
  4. Push the media guide to left, until you pushing both upper- and lower sensor (The sensors must be within the label width)
  5. Push the media guide to right
  6. Lift upper sensorarm and install labels
  7. Push the media guide to left until the media guide toushing the label
  8. Lower the sensorarm and close the printheadsection
  9. Press FEED to control if the printer works
  10. Åben topcover og derefter printhovedsektion (Blå knap)



/ Solution no. 2 (Sensor Calibrering):

  1. Open topcover and printheadsection (Blue button) and lift upper sensorarm
  2. Peel off labels from back paper, until you have 10 cm back paper without labels (place the back paper in between the sensors)
  3. Lower the sensor arm and close the print headsection
  4. Turn off the printer
  5. Press and hold the 3 buttons on the front panel (PAUSE, FEED and STOP)
    - Turn on the printer
  6. Release the 3 buttons when CONDITION is on
  7. Press and hold MODE/REPEAT button and press PAUSE (the printer will growl and slowly feed the back paper)
  8. Release MODE/REPEAT button
  9. Press STOP to save the calibration
  10. Press FEED to control if the printer works